Align 450 esc setup

Gear ratio: Sensor configuration: 3 That is six "poles"--the six magnets around the inside of the motor's "can," not to be confused with the nine stator windings--divided by 2. The next two settings are probably very transmitter-dependent and included just for reference.

Autorotation bailout: I haven't enabled this yet, but I've been experimenting with it. The electric governor setup pages at www. Main menu:. Transmitter setup:. Note, however, that efficiency is best when a motor is running close to its maximum speed.

Brake: Disabled. Timing: Mid-timing. Battery protection: High cutoff. Aircraft: Airplane. Throttle response speed: High. Voltage: 6 v. Setting up the Governor on mini VBar. You have to hit Reset after you select "Electric. At one point in the setup you control the throttle with the collective stick. Make sure your pitch is set linearly from 0 to or you will get weird results. Home Site Map Contact Twitter This information is provided "as is" with no warranties, and confers no rights.

In no event shall the author be liable for indirect, special, incidental, or consequential damages of any kind arising from any error in this information, including without limitation any loss or interruption of business, profits, use, or data. All rights reserved. Check out the recommended reading list. Small Transmitting Loop Antennas. Full-Wave Loop Antennas. Quarter-Wave Vertical Antennas. Coil-Shortened Vertical Antennas. Dipole Antenna Length.

Coil-Shortened Dipole Antenna. The second option gives you 16 channels with your X6R, which is to configure it to S-Bus. Again there should be a cable in your set. I used the main port cable with the thre single connectors, works perfect. How to set up a Heli is not my domain, but there are a few people here who can help you with that part.

Quote from: cato on December 05, , am. Is your trex with or without flybar? I am trying with a flybarless and it is a success, but without flybar Yesterday it exploded all the blades eway!

I'm trying a t-rex without flybar and it fly well! If you need concact me for the. Lahiru 8 Build. Anyone have used cc3d on flybarless heli? Quote from: Lahiru on December 20, , pm. SamSam 27 Quads Helis planes. Yes this is very good controller, it took a while to figure out all the settings, as I was done open pilot site went down, so I am exited that this forum is up and running..